Increasing the Life of Projector Lamps – Here’s Your 101 Guide

Like many bulbs, the projector lamp is a rather delicate object albeit which is definitely much more expensive than the average household bulbs, therefore it is important to ensure your lamps last as long as possible. It is surprising to see that some places have the requirement of a new projector every few years, while some require them every few months.

The Epson H433B projector lamps come with some of the most amazing features and an impressive number of lamp hours – something that the people look for when it comes to making such a huge investment. Despite such good lamp hours it is still vital to take some measures to improve the life of the lamp. Here is some advice that you might need to ensure your projector lamps last as long as possible; read further for the details.

1.      Let the Projector Cool Down: A primary reason why the projector bulbs need replacement more often is because the people do not allow the projector lamp to cool down before the move the projector or switch it on again. You’d see that many projectors power down on their own, so it advised that you do not move the projector whilst it is still in this mode.

 

In case you have an older projector model, you might as well have an on/off switch for the bulb and a separate on/off switch for the machine. In this case, it is important to switch the projector off first and once it has powered down, you can switch the projector off.

 

In a similar way, it is always suggested that you do not shake or bump the projector whilst the projector still lies in the switched on mode. Remember the projectors in this mode are very sensitive and any kind of movement could cause the projector to blow or shorten its life.

 

2.      Overheating: If you see that the projector bulb is overheating, then you’ll see the bulb will burn out earlier than it should. The main reason for overheating is when the users do not clean the projector filters on a regular basis. The thing about the bulbs is the they should be cleaned once every three months or so using a can of compressed air; however, the frequency should be increased to monthly if the projector lies in a dusty environment.

 

Another reason why the projector lamps are overheated is because is some blockage in the fan exhaust; therefore, it is imperative to take a note of where the fan is in your projector and make sure it has a minimum of two or three feet of room to breathe. Also, make sure you never touch the lamp because the fingers have natural oil on them and this causes the projector lamp to naturally overheat and burn out prematurely. It is for this reason that you’re always advised to touch the metal housing instead.

 

3.      Keep the Projector at Room Temperature: Projector lamp sales always increase in the spring or after summer holidays. The main reason for this is that people leave their projector in the cold over winter or even in the car for a day or two. The quick change in temperature will cause a projector lamp to blow if you switch a cold projector on so let it warm to room temperature first. Never leave the projector in the car or in extreme heat because the projector lamp will overheat and burn.

These are definitely three simple tips but often the most ignored ones and that is why it is advisable you take of note of these to improve the overall life of your projector lamps.

Also, if you are looking for the Epson H433B projector lamps in Australia, then you can choose to buy them online from Aussie Lamp Centre – Australia’s one stop destination for some of the best options of projector lamps online, all of which are available at extremely budget friendly prices.

For more details or to order your projector lamps online, you can log on to https://www.aussielampcentre.com.au/